Tek TDS 220 scope teardown

image

image

image

This was a broken scope considered beyond worth to repair by service, but I got it working again… (white tape that holds jumper wire going to display connector).

Thank you for service manuals in Internet. Google search and YouTube are repair hacker’s friend.

Posted from WordPress for Android

9 Comments

  1. Tomi Engdahl says:

    Fixing a broken CCFL Backlight
    http://hackaday.com/2016/06/10/fixing-a-broken-ccfl-backlight/

    When you work at Tektronix and they make a difficult to refuse offer for their ‘scopes, you obviously grab it.

    Jason Milldrum] got his unit before cheaper, and better ‘scopes appeared on the market. It served him well for quite a long time. But keeping it switched on all the time took a toll, and eventually the CCFL backlight failed. Here’s how he replaced the CCFL back light with a strip of LED’s and revived the instrument.

    Searching for an original replacement CCFL backlight didn’t turn up anything – it had been obsoleted long back.

    the CCFL can be replaced by a thin strip of SMD LEDs powered by a DC-DC converter.

    The original DC-DC converter supplied along with his LED strip needed a 12V input, which was not available on the TDS1012.

    TDS1012 LED Backlight Retrofit
    http://nt7s.com/2016/05/tds1012-led-backlight-retrofit/

    Reply
  2. Tomi Engdahl says:

    EEVblog #690 – TDS220 Oscilloscope Autopsy
    https://archive.org/details/EEVblog-188_20141207

    Dave dissects and then powers up the Tektronix TDS220 oscilloscope used in the Mud Run. Did it survive?

    Reply

Leave a Comment

Your email address will not be published. Required fields are marked *

*

*