Mastech MS2600 Electrical tester

Have you just recently bought or used a new electronics tool or product that was very good or something other readers should avoid? Post your comments and product test results here.

Mastech MS2600 Electrical tester

Postby Tomi Engdahl on Wed Jun 28, 2006 5:41 pm

Product: Mastech MS2600 Electrical tester
Product type: Open jaw multimeter intended for electrical installation testing
Manufacturer: Mastech http://www.p-mastech.com/
Product home page: http://www.p-mastech.com/newproduct/enl ... ms2600.htm
Product price: 25 Euros to 59.95 Dollars
Bought from: Yleiselektroniikka http://www.yeoy.fi/

MS2600
ELECTRICAL TESTER

SPECIFICATIONS:
MS2600 IS AN OPEN JAW DIGIT ELECTRICAL TESTER. THERE ARE DCV. ACV, ACA, CAP, FREQUENCY, DIODE TEST, CONTINUITY TEST AND DUTY CYCLE TEST FUNCTION. OTHERWISE THERE ARE AUTO AND MANUAL RANGE, RELATIVE MEASUREMENT, DATA HOLD, AND BACKLIGHT AUTO OFF TIME LIMIT MODE. TEST LEADS CAN BE INSERTED ON GROOVE OF BACK OF THE TESTER.

* Meets Iec1010-1 Concerning Safety Requirements. Category III, 600 VAC rated
* Display: 1999 Counts
* DCV: 4/40/400V±0.7%, 1000V±0.8%
* DCV: 4/40/400V±0.8%, 700V±1.0%
* ACA: 400/1000A±3.0% (50Hz to 400Hz)
* Resistor: 400/4k/40k/400k/4MM Ω±1.2%, 40MM Ω±2.0%
* CAP: 4n/40n/400n/4μF±4.0%
* Frequence: 10Hz to 100KHz±2.0%
* Duty Cycle: 0.1% to 99.9%
* Backlight Auto Off Time Limit Mode.
* Power: Battery 6F22 (9V) x1
* Size: 192x68x43mm
* Weight: Approx. 230g


Image
image source: http://www.elektroimportoren.no/default ... op&Item=80

Image
Image source: http://www.multimeterwarehouse.com/MS2600.htm

My comments:

I tested the blue version (on the upper picture).

This meter is well worh of the price. it works as advertised and seems to be well constructed. Comparung to the features it has at the lowest price this is a bargain comapred to the features it has. Instrument worth to take to the field and carry in a soft case with a strap (comes in meter package).

If you are looking for a cheap open jaw current meter plus multimeter this product is worth to check out. Open jaw is the special part of this meter, much easier to use than traditional clamp meters in many case. The open jaw measuring works for AC currents from 100 mA up to 200A (100 mA resolution).

The design is good for intended purpose.
The meter fitst nicely on the hand and is easy to operate even with one hand only. The shape of the case is such that it can hold the tips of the measurement leads (hold one tip on the meter that is on your left and and then use right hand to control the location of other tip).
The open jaw part of this meter works well, bit could be a little bigh for very tight electrical installations. Check your your intended use.

General notes on open jaw multimeters: There are other open jaw meters that have open jaw parts that can be placed to tighter spaces and some even measure DC. Those meters are much much more expensive.
Tomi Engdahl
Site Admin
 
Posts: 1839
Joined: Mon Oct 20, 2003 6:15 pm
Location: Espoo, Finland

Return to Product Tests and Comments

Who is online

Users browsing this forum: No registered users and 4 guests

cron