Cable-damage HP 1702 - COLOUR-CODED pinout needed

[fredfredfred]

Hi ,
I have a damaged vga cable on hp 1702.
does anyone have the VGA cable colour-code pinout ?

Thanks,
very much appriciated

[samsung_5314]

I have the same :S

[Tomi Engdahl]

Thare are no universal VGA cable colour-code pinouts. Different cable/equipment makers use different colors in their cable.
I don't have colour-code pinout specific to hp 1702.

But I have one tip: check this generic documentation on how to identify signals on VGA monitor cables:

Identifying connections on unknown or cut monitor cables
http://www.epanorama.net/documents/pc/svga_wiring.html

"The procedure is described with respec to a cut cable but if you are trying to identify an unknown connector type on the monitor"

[help me!]

hey
i have the smae problem
i think i have dammaged the wire internally
what can i do about this as on the hp 1702 u cannot replace the vga wire...
plz help

[Guest]

I got an HP1702 monitor without VGA cable, so I had to find out the pinout. I did it with help of datasheet of the image chip. You will have to open the monitor to see wire colors.
The internal VGA pinout is as follows:
Pin Signal DB15 pin
1 Cable detect 5
2 Blue ret 8
3 Blue 3
4 Green ret 7
5 Green 2
6 Red red 6
7 Red 1
8 H sync 13
9 V sync 14
10 GND 10
11 SDA 12
12 SCL 15
13 V+ 9
14 GND 4, 11

Regards, Bostjan Glazar