Measuring AC power with the Industruino PROTO

https://blog.arduino.cc/2016/11/21/measuring-ac-power-with-the-industruino-proto/

This project uses DIN rail mountable Arduino to measure electrical power consumption.

This robust DIN rail mountable, Leonardo-compatible controller enables you to take your existing Arduino projects and swiftly transform them into permanent installations. The prototyping area and screw connectors allow you to install your own circuitry and reliably connect to accessories.

 

Interview With Arduino AtHeart Partner Industruino

Loic De Buck talks with Davide Gomba about the Industruino PROTO, a robust DIN rail mountable, Leonardo-compatible industrial controller with an LCD display. It enables you to take your existing Arduino projects and swiftly transform them into permanent installations. The prototyping area and screw connectors allow you to install your own circuitry and reliably connect to accessories.

 

2 Comments

  1. Tomi Engdahl says:

    Review: SmartPi – smart meter extension for Raspberry Pi
    https://www.elektormagazine.com/news/review-smartpi-smart-meter-extension-for-raspberry-pi

    What is the SmartPi?
    The SmartPi is an extension board to turn a Raspberry Pi into a smart energy meter. All the parts, including the enclosure, are available separately but it is also possible to buy a fully assembled device (discussed here). The assembled version is built on a Raspberry Pi 3 model B.

    The SmartPi can measure current (up to 100 A, with a hardware modification up to 300 A is possible), voltage (up to 400 V) and frequency on three phases plus neutral and calculate several flavors of power (active, reactive & apparent) and consumption.

    The software is open source and available from GitHub.

    The evaluation SmartPi came with three current sensors.

    The web interface showed three currents, three voltages and three frequencies.

    Conclusion
    The SmartPi is a Raspberry Pi extension board for makers, not a consumer product. The software supporting it is basic — three-phase only, configuration over SSH —, documentation is insufficient. People without RPi or Linux experience will be lost quickly.

    On the other hand, if you are looking for a platform on which to build yourself a smart energy consumption metering system, the SmartPi definitely is a good start.

    Reply

Leave a Reply to Tomi Engdahl Cancel reply

Your email address will not be published. Required fields are marked *

*

*